Im new to this forum. I have a 2007 Honda Accord Executive that is K24a3 swapped. The car has a few bits done to it, one of which is a Ktuner V1.2 I presume and it was dyno tuned about a year ago by the last owner. I was a little sceptical that the car was running a little leaner than it should be so I wanted to have a look at the tune using the Kruner software on my laptop but when I connect it does not show anything on the screen other than the rev dial and a few boxes to the right that display some readings from some sensors.
I can go ahead and start a new tune but I dont know how to save the current one, or if I do start the new tune will it automatically save the old one?
Thanks everyone in advance, have a lovely day!