KTuner.com

I have a CL7R and I tired to load a basemap into the ktuner

I have some issues on the following based on what I tried

K20z1 rsx , k20a3 rsx, K20a jdm rsx: engine start fine, idle is steady but the rpm gauge doesn’t work

K24 usdm tsx: engine start fine, runs fine , engine light on because this is not dbw

Any help will be appreciate, been stuck on this for a long time with an ecu which I cannot use

Thanks

You're posting in the 03-05 Accord section, but that doesn't seem to be an option you've tried in the software according to this post. Start with that one.

it is 05 CL7 Euro R, I also tried the 03-05 accord

It stalled and engine light on

03-05 is drive by cable Accord codebase. If you have a drive by cable ECU listed on the 03-05 Accord page and drive by cable vehicle that'd be the one to use.

Check the error code. Have it properly tuned.

Thanks for the reply

I found out the cam angle on the 03-05 Accord is 0 10 20 30 40, but on the K20 map it suppose to have 0 15 30 45 50.

Is that means I cant use the 50 on the Accord map?

Much appreciate

It's interpolated, so anything passed 40 would use the 40 table.