Reflash Issues
Posted: Tue Sep 27, 2022 1:14 am
The first time I flashed my ECU I had no issues. Then reflashed my ECU and ended up going into recovery a few times but eventually was successful. I figured the ECU was back to stock. The battery was also dead so I charged it up a while. After starting it up I noticed a few warning lights (Brake, Tire pressure, Traction control, ABS) So I shut it off and flashed it to factory. After starting it up I noticed none of the lights went away and the steering light was on and a slightly rough idle that wasn't there before.
Ktuner module says there are no codes. Is it possible I just need to drive it to restart the systems?
Ktuner module says there are no codes. Is it possible I just need to drive it to restart the systems?