Reflash Issues

Questions about your KTunerFlash V2 Hardware
Post Reply
redxnemesis
Posts: 8
Joined: Thu Sep 08, 2022 1:25 am

Reflash Issues

Post by redxnemesis »

The first time I flashed my ECU I had no issues. Then reflashed my ECU and ended up going into recovery a few times but eventually was successful. I figured the ECU was back to stock. The battery was also dead so I charged it up a while. After starting it up I noticed a few warning lights (Brake, Tire pressure, Traction control, ABS) So I shut it off and flashed it to factory. After starting it up I noticed none of the lights went away and the steering light was on and a slightly rough idle that wasn't there before.

Ktuner module says there are no codes. Is it possible I just need to drive it to restart the systems?
KTuner
Site Admin
Posts: 3744
Joined: Mon Jul 22, 2013 8:13 pm

Re: Reflash Issues

Post by KTuner »

KTuner only shows you error codes in the ECU, as that's the only module we flash. if your unit is up to date on firmware then clearing codes does issue a clear command for all modules.
Post Reply

Return to “KTunerFlash V2 Specific”