Page 1 of 1
Building a turbo Fit
Posted: Thu Oct 08, 2020 5:52 am
by Energyboy5696
Hey Guys,
I have a 15 and was wondering if the Ktuner V2 would be a good tuner to go with for my turbo Fit build.
Other than if it's a good possibility, my only specific question is if I can wire in an electronic boost controller and control it via the Ktuner device.
Thanks!
Re: Building a turbo Fit
Posted: Thu Oct 08, 2020 11:31 am
by KTuner
There is no forced induction support for that ECU.
Re: Building a turbo Fit
Posted: Thu Oct 08, 2020 3:11 pm
by Energyboy5696
That's a very unhelpful and short response. If it's a tuner, I should be able to tune in more air. Is this not the case?
Re: Building a turbo Fit
Posted: Thu Oct 08, 2020 4:00 pm
by KTuner
For a naturally aspirated setup, yes. The ECU isn't coded for forced induction support from the factory and you'll be fighting an uphill battle. The response was perfect for letting you know that.
Re: Building a turbo Fit
Posted: Thu Oct 08, 2020 8:15 pm
by Energyboy5696
I'm ready to fight that battle to the top of the hill, friend. I'm keen on using the Ktuner as it's such a good medium for dyno tuning.
Would I at least have live AFR reading with the device
Re: Building a turbo Fit
Posted: Fri Oct 09, 2020 11:46 am
by KTuner
You'll have full datalogging capabilities, yes.