Closed Loop Lambda Target
-
- Posts: 8
- Joined: Sat May 02, 2020 9:02 pm
Closed Loop Lambda Target
Hey is the Closed Loop Lambda Target LOW LOAD VS HIGH LOAD Just representing the the different cams(Vtec on or off) Or is it just load? I'm trying to lower AF/R's under partial throttle, around 50% throttle. I changed the high load setting but it didn't effect it.. Knock Control shoots up under partial throttle then goes back down under WOT and cruising.. Was going to change ignition tables to be less aggressive in this area but it is the same cells as WOT tune.
Re: Closed Loop Lambda Target
It is based on a combination of RPM and Manifold Pressure.
-
- Posts: 8
- Joined: Sat May 02, 2020 9:02 pm
Re: Closed Loop Lambda Target
Can I change the Mbar numbers under load on the ignition tables, my MAP never goes to 1000, so more then half the tables aren't being used. It lets me change the numbers but I've never seen that being talked about before.
Re: Closed Loop Lambda Target
You can, but we don't recommend messing with that on this platform.