Closed Loop Lambda Target

Post Reply
TurboEclipse
Posts: 8
Joined: Sat May 02, 2020 9:02 pm

Closed Loop Lambda Target

Post by TurboEclipse »

Hey is the Closed Loop Lambda Target LOW LOAD VS HIGH LOAD Just representing the the different cams(Vtec on or off) Or is it just load? I'm trying to lower AF/R's under partial throttle, around 50% throttle. I changed the high load setting but it didn't effect it.. Knock Control shoots up under partial throttle then goes back down under WOT and cruising.. Was going to change ignition tables to be less aggressive in this area but it is the same cells as WOT tune.
KTuner
Site Admin
Posts: 3745
Joined: Mon Jul 22, 2013 8:13 pm

Re: Closed Loop Lambda Target

Post by KTuner »

It is based on a combination of RPM and Manifold Pressure.
TurboEclipse
Posts: 8
Joined: Sat May 02, 2020 9:02 pm

Re: Closed Loop Lambda Target

Post by TurboEclipse »

Can I change the Mbar numbers under load on the ignition tables, my MAP never goes to 1000, so more then half the tables aren't being used. It lets me change the numbers but I've never seen that being talked about before.
KTuner
Site Admin
Posts: 3745
Joined: Mon Jul 22, 2013 8:13 pm

Re: Closed Loop Lambda Target

Post by KTuner »

You can, but we don't recommend messing with that on this platform.
Post Reply

Return to “16-21 Civic 2.0”