2005 RSX Base Manual end user board
So after reading the online help section I wired my flex fuel sensor directly on my end user board. The software does not give me an option to turn on flex fuel so I assume it sees voltage on those pins and knows what to do.
However, My active table indicators stay red. My logs show fuel temp and sometimes frequency but never a ethanol content % reading. All my wiring seems to be fine unless there is something I am missing.
Just looking for some direction.
Flex Fuel Wiring
Re: Flex Fuel Wiring
Check your grounds. If the sensor is sending a signal, and the unit is receiving, the software will show the data.