k24a2 long block

[cramos098]

so im planning on swapping in a stock k24a2 long block in my 05 type s. do i just need to load the base map for the k24a2 thats on the list or do i still need to get it tuned to run smooth. i dont want to run rich or lean once i get the car running. i will be getting it tuned once i get and i/h/e. will i be fine with the base map on the program

[KTuner]

Basemaps are just meant as a starting point. There's a good chance it will run the setup, but you should consult a tuner to verify or fine tune as necessary.

[dropdead]

OK, if I have a 05-06 base auto RSX - should I stick only with PND Auto basemaps as a starting point and tune from there, or other basemaps (PND MT, PRB, etc..) can be used too?

thank you

[KTuner]

If you have an AT and run a MT program your transmission will not function. Stick to the AT basemaps.

[cramos098]

so i will be able to drive the car for a while till i get time to get the tune. nearest tuner i have is about an hour away from me

[KTuner]

You can use the software to monitor how the vehicle is performing. If you're not sure what to look for I'd recommend consulting a tuner before hammering on it in any capacity.