P0365 Disable After J32 Head Install

Post Reply
SuperZ2
Posts: 1
Joined: Sun Mar 19, 2023 9:35 pm

P0365 Disable After J32 Head Install

Post by SuperZ2 »

Hey there KTuner, I'll try to keep this short and sweet. After about a year of planning, I was finally able to swap out the J35 VCM heads to J32a2 vtec heads out of an Acura TL. (I know the Accord PCM doesn't allow for vtec tuning, but I have plans for a piggyback system in the future. One step at a time here). To the best of my knowledge, nobody has any record of this head swap. I've gotten the car to shut up about the VCM solenoids finally, but it's still in a limp mode due to a P0365 code. I tore the timing apart and replaced the CMP sensor just in case I damaged it during install. No dice. I then replaced the cam pulley with the stock one. Still nothing. Any chance you could allow support for a disable here? Or any other ideas to help me out? The car runs, but revs are limited to 3 grand. The fact that it runs gives me hope. Thanks.
KTuner
Site Admin
Posts: 3745
Joined: Mon Jul 22, 2013 8:13 pm

Re: P0365 Disable After J32 Head Install

Post by KTuner »

Anything available in the software is what is available for this purpose.
Post Reply

Return to “08-12 Accord V6 Specific”