Had my r18 tuned recently, and found out changing 2 step and obd2 stuff doesn't work.
2 step will always default to stock limiter of 3800-4000
Disables kind of work? Disabling primary o2 sensors doesn't throw a CEL but it stops my wbo2 from working. Haven't tried any other disables
Also, I've made sure that my cals are uploading properly, and they do seem to. So I'm not sure what I'm doing wrong
ECU: 37820R1AA040M1
Software: 37805-R1A-3050 (this might be something)
Disables and 2 Step not working
Re: Disables and 2 Step not working
What are you changing the 2-step to?
Disabling primary O2 would stop the primary O2 from operating, so sounds like it worked.
Disabling primary O2 would stop the primary O2 from operating, so sounds like it worked.
Re: Disables and 2 Step not working
I tried different numbers with none working. 4700 restart, 5000 limit was my first try, didnt work. Tried a lower number, 2500 restart, 2600 limit. Didn't work.
And for the primary o2, shouldn't it throw my car into limp mode if its disabled?
Re: Disables and 2 Step not working
I'll take a look.
No. It just won't use it for feedback because it's disabled.
No. It just won't use it for feedback because it's disabled.
Re: Disables and 2 Step not working
No updates.
At the top left of the tuning table (Left side of the toolbar above the table) is a square for the drop down. Click it.
At the top left of the tuning table (Left side of the toolbar above the table) is a square for the drop down. Click it.
Re: Disables and 2 Step not working
Any chance the R18 will get a fix for the 2step? Or will it just be shelved due to the new 11th gen coming out?
Re: Disables and 2 Step not working
It's still on a list of things to do.