Retaining ECO button features and setting DBW to be linear

Post Reply
WhiteOrchid
Posts: 12
Joined: Sat May 11, 2019 2:30 pm

Retaining ECO button features and setting DBW to be linear

Post by WhiteOrchid »

If I wanted to retain the ECO button features other than the altering of the throttle map, would I just make the ECO DBW map look the same as the standard DBW map?

Also, if I wanted the throttle map to be strictly linear, how would I set the map? I'm new to this all so all the numbers and buttons on the chart mapping page are a little confusing.

TIA
KTuner
Site Admin
Posts: 3744
Joined: Mon Jul 22, 2013 8:13 pm

Re: Retaining ECO button features and setting DBW to be line

Post by KTuner »

You can certainly alter ECO DBW with that map if you have access to it.
WhiteOrchid
Posts: 12
Joined: Sat May 11, 2019 2:30 pm

Re: Retaining ECO button features and setting DBW to be line

Post by WhiteOrchid »

I do appear to have access to it, however the map charts for ECO Base and Final appear to be on different scales. Not sure how to make them equal exactly.

***EDIT*** I see why they look different. The ECO base chart is TP/KPH while the Final is TP/RPM. Not sure how to get them to appear on the same scale so I could make them equal.
KTuner
Site Admin
Posts: 3744
Joined: Mon Jul 22, 2013 8:13 pm

Re: Retaining ECO button features and setting DBW to be line

Post by KTuner »

Final should not match ECO or vice versa. The Final DBW table uses the output of the standard table as it's incoming TP value.
Post Reply

Return to “Accord / CL7 Euro-R Platform”