I found a problem ...
Edit> preferences> Wideband> Gas Type
After installing Ktuner 1.0.10.9 the default is 14.0
No fuel is selected.
When I choose Gasoline 14.7 then AFR.CMD increases by 0.7 and returns to the target from the WOT tables. Everything is OK with the map I am uploading.
The problem is with the Ktuner software
The software does not remember these settings. When I turn Ktuner off and on again, the Gas Type settings go back to 14.0 ...
AFR Problem - AFR.CMD vs AFR TABLE
Re: AFR Problem - AFR.CMD vs AFR TABLE
The problem is with your selection of decimal point. See, a point is a dot, like a period at the end of a sentence.
.
Not a comma or anything else.
.
Not a comma or anything else.
Re: AFR Problem - AFR.CMD vs AFR TABLE
You have to set the decimal separator to "." instead of "," in the Windows region settings.MrCk wrote: ↑Tue Dec 07, 2021 10:03 pm I found a problem ...
Edit> preferences> Wideband> Gas Type
After installing Ktuner 1.0.10.9 the default is 14.0
No fuel is selected.
When I choose Gasoline 14.7 then AFR.CMD increases by 0.7 and returns to the target from the WOT tables. Everything is OK with the map I am uploading.
The problem is with the Ktuner software
The software does not remember these settings. When I turn Ktuner off and on again, the Gas Type settings go back to 14.0 ...