Key cycle error

Questions about software installation and registration
Post Reply
cxcamirand
Posts: 1
Joined: Wed Oct 30, 2019 12:16 am

Key cycle error

Post by cxcamirand »

Hi,

Just installed the Ktuner to my wife 2019 Crv. I can get the 19.5psi base map flashed but once I gotta do the on/off key cycle I always get a error message telling me I did it wrong. My question is: Does it affect the tune upload? Car run fine exept of all error codes showing in the dash, which from will likely erase after driving for a while.
Thanks a lot
KTuner
Site Admin
Posts: 3741
Joined: Mon Jul 22, 2013 8:13 pm

Re: Key cycle error

Post by KTuner »

If the car runs fine then the flash was successful. Keying off and on resets all systems and the unit communication, which checks for success.
Post Reply

Return to “KTuner Software Installation”