KTuner.com

I've got a 2006 TSX and I'm using a 2007 TSX Automatic ECU.

I'm getting these error messages that have to do with the lack of the automatic transmission.
P0974 - Shift solenoid (SS) A -control circuit high
P0977 - Shift solenoid (SS) B -control circuit high
P0962 - Solenoid A Control Circuit Low
P0980 - Shift Solenoid C Control Circuit High
P0966 - Pressure Control Solenoid B Control Circuit Low
P0970 - Pressure Control Solenoid “C” Control Circuit Low
P0983 - Shift solenoid (SS) D -control circuit high
PO986 - Shift Solenoid 'E' Control Circuit High
P0713 - Transmission Fluid Temperture Sensor Circuit High Input
P0706 - Transmission Range Sensor Circuit Range / Performance

Can these be removed? Or can I be supplied a new basemap with the 50 degree VTC that is made for a manual?

The AT ecu's are a whole lot easier to find and definitely cheaper.

Thanks!
- Jason

Will update the software so you can open and flash an MT calibration.

KTuner wrote:Will update the software so you can open and flash an MT calibration.

Woohoo! Will this be a beta or should I keep an eye on the application change logs?

Using the Manual Transmission base map fixed the issues! Thank you!