Hi folks,
I've got a bit of an odd duck situation but the TLDR is that I'm getting the P0600 error code because the car I have doesn't have the multiplexer from the donor car. Is there a way to disable this? I've looked through the software but not found anything.
Now for the full specs.
I have a k24a2 with a k24a4 wiring harness and a RAD ecu (rad )
I am using the k24a2 basemap for the PRB ecu that is drive by cable (This one runs the motor and I don't have a tuner yet)(Also I would copy the maps from the TSX basemap over the k24a4 basemaps if it wasn't such a pain, any tips and tricks there would be awesome.)
The motor is in a mk4 VW Golf.
I have no other diagnostic codes.
If anyone has been in the same spot I'd love to know what you know!
Edit: I know that this code doesn't affect the performance of the engine in any way but I'm in Texas and if we have any codes we will pass emissions and I won't be able to re-register this car.
P0600 Multiplexer Disable
Re: P0600 Multiplexer Disable
That's interesting. We have a lot of swap vehicles not popping up with this one. We can look into it.
Re: P0600 Multiplexer Disable
Yeah I'm curious if I'm missing something. Our CAN lines are just hanging free in the wind so worst case maybe I can find the multiplexer at the yard.KTuner wrote:That's interesting. We have a lot of swap vehicles not popping up with this one. We can look into it.
I appreciate you looking into it and let me know if you want me to send you any data/information.
Re: P0600 Multiplexer Disable
It may mean something is connected to the multiplexer output, enough to trigger this. Follow up in email please.