Good evening KTUNER.
Getting ready to install a FLEX sensor on my K Swapped Supercharged CRX. I see in the Help section the in the Ktuner Rev 1 the right two pins are used. The right pin is ground, the middle pin is for the flex fuel input.
I have a Rev 1.1, is the pin out still the same?
FLEX sensor pin
Re: FLEX sensor pin
Rev 1.1 is a Rev 1. Ground can be used as common ground, not to ground the sensor completely.
-
- Posts: 14
- Joined: Tue Apr 21, 2020 2:33 am
Re: FLEX sensor pin
Yes and the ground can be connected to the common ground for the sensor.
-
- Posts: 14
- Joined: Tue Apr 21, 2020 2:33 am
Re: FLEX sensor pin
Wiring done, sensor plummed.
As far as the software (Yes, I will get it profesional tuned, But for now I need the car to drive). Do I have to do both, change the fuel type under preferences>Fuel setting to Ethanol and set the FLEX table? Or is the FLEX Table the only thing to adjust when dealing with FLEX fuel.
I am not running all the time Ethanol.
As far as the software (Yes, I will get it profesional tuned, But for now I need the car to drive). Do I have to do both, change the fuel type under preferences>Fuel setting to Ethanol and set the FLEX table? Or is the FLEX Table the only thing to adjust when dealing with FLEX fuel.
I am not running all the time Ethanol.
Re: FLEX sensor pin
Preferences is for logging. ECU settings are in the tune parameters.