Quick question,
I am trying to connect Tunerview with Ktuner v1.2 on a Accord 2.0t.
My question is about the Datalog protocol, I have choice of R1, V2, or V1.2.
Which one should I select in setup?
I would think v1.2, but have seen videos that are all different, including the official tutorial video (R1)
Tunerview setup
Re: Tunerview setup
The one that matches what you have.
Re: Tunerview setup
Thanks,
The only reason I asked is because I can pair the unit with my device, then connect within the app with no problem. But all the gauges read zeros, i never get it to work. All permissions given, not sure what’s going on.
I’ve used a Amazon Fire 7 (2019) and a Android 11 tablet (2022)
The only reason I asked is because I can pair the unit with my device, then connect within the app with no problem. But all the gauges read zeros, i never get it to work. All permissions given, not sure what’s going on.
I’ve used a Amazon Fire 7 (2019) and a Android 11 tablet (2022)
Re: Tunerview setup
If the unit LED is blinking because it's connected to the vehicle with key full on then data should be getting relayed. If not go back and respond to the email chain you started before this, perhaps with a better attitude.