KTuner in ECU communication failure
Posted: Wed Jan 26, 2022 6:11 am
Hi, I just bought a used KTuner ecu installed on PND-A65 ecu, and try to connect it with my integra dc5 year 2006 swapped with k24a3 engine. The problem is whenever i wanna connect throught software, the connection is failing and intermittent retry.
What is the possible issue here?
Is there any sequence on how I ; connect the KTUner to ecu , turn on the engine so that the ecu is powered up, open up the KTuner software. Because right now i just plug in the usb cable, open the software, and then when the software is loaded , turn on the engine (not start it, just to power the engine)
appreciate your help on this problem
What is the possible issue here?
Is there any sequence on how I ; connect the KTUner to ecu , turn on the engine so that the ecu is powered up, open up the KTuner software. Because right now i just plug in the usb cable, open the software, and then when the software is loaded , turn on the engine (not start it, just to power the engine)
appreciate your help on this problem