Can’t get PWM to work with pzd ecu

Post Reply
Busa
Posts: 5
Joined: Sat Sep 25, 2021 8:27 pm

Can’t get PWM to work with pzd ecu

Post by Busa »

I’m having a issue where I can’t get any boost but wastegate pressure. Im using a MAC solenoid with one wire to ign 12v when on and the other to b21 with it enable in the software and nothing. I tried with two solenoid, one 4 port and the 3 port with no luck. I’m using the ktuner PRB codebase boost support, Is there something that I’m missing?
KTuner
Site Admin
Posts: 3744
Joined: Mon Jul 22, 2013 8:13 pm

Re: Can’t get PWM to work with pzd ecu

Post by KTuner »

If it's properly setup you'll see PWM Duty in logging. If so the ECU would be outputting.
Post Reply

Return to “KTuner Software”