How do I set Digital Gauge with Analog Input?
Posted: Sat Oct 09, 2021 9:39 pm
Hello Members,
I'm using an AEM Oil Pressure Gauge. I also have it connected to the R1 PCB KTuner Board on Analog Input 1. In the software under preferences, I see my four analog options where I can add a value. However, if I hit + to add a value, I'm not sure what value to enter here. I took a stab at it and tried entering something from 0-5 in the value field but then the Digital Gauge I set for Analog Input 1 gets no reading. However, if I don't enter any value in the field, I do get a reading.
The issue is that it looks I am just getting a voltage reading from that signal rather than my oil pressure reading. See the image I have attached. Am I going about this wrong? Is the input only to read some voltage to indicate a functioning powered source rather than actually reading units of measurements, in this case PSI of Oil Pressure?
Thanks
I'm using an AEM Oil Pressure Gauge. I also have it connected to the R1 PCB KTuner Board on Analog Input 1. In the software under preferences, I see my four analog options where I can add a value. However, if I hit + to add a value, I'm not sure what value to enter here. I took a stab at it and tried entering something from 0-5 in the value field but then the Digital Gauge I set for Analog Input 1 gets no reading. However, if I don't enter any value in the field, I do get a reading.
The issue is that it looks I am just getting a voltage reading from that signal rather than my oil pressure reading. See the image I have attached. Am I going about this wrong? Is the input only to read some voltage to indicate a functioning powered source rather than actually reading units of measurements, in this case PSI of Oil Pressure?
Thanks