KTuner.com

So ive had my KTuner end user kit for about over a year now and once in a while when im driving, the ecu will turn off and turn back on by itself, it makes a tick noise and the car jerks back hard and the engine light flashes. Its pretty scary sometimes it just happens out of nowhere, i was just wondering if anyone else had these strange issues?

Which ECU codebase did you start with?

KTuner wrote:Which ECU codebase did you start with?

Im running the PRB ecu package from HA Motorsports

Which ECU codebase did you choose to start with?

KTuner wrote:Which ECU codebase did you choose to start with?

Not sure what you mean by codebase but im using the I/H/E/RBC basemap if thats what you mean.

We'll look into it. Thanks.

I have same problem late summer,now when i read Ktuner question for wich codebase is used i want to ask if ECU is from auto vechicle who codebase can use for tune?Inecu sofware have codebase calibrations for auto and manual.If car is mapped with MT calibration but with AT ecu can happen this problems with resets?

No, running MT on an AT ECU is fine to do.

I have same issue on my 0607 accord in-ecu board from I bought it on 2018, I use 0607 RAD factory AT basemap from software and also posted on specific forum board but not solved, so I stopped to use it from that time and keep watching the forum for solution for quite long time.

I have 04-05 Accord RAD ecu and today again ecu still reset after i turn ... Whats happen with these ecus?Please pay attention to this problem before someone breaks their engine...??