KTuner.com

So which sensor exactly is ect2? Prior to my swap I had a coolant gauge and fans, im just trying to figure out what exactly is disabled. It could be my new swap harness but since its a dual ecu harness I wanted to get some info from you guys. I should of returned to factory before doing all this cau...

WOT enrichment stops at atmospheric pressure so what or where is it pulling this # to target/command. Specifcally in open loop?

Thank you!

can you explain this number?

I assumed commanded, but dont it has capabilities like that in boost and 0% STFTs and LTFTs.

Is this the OEM o2 "adjusted" o2?

My apologies its P0128 which did not come on until I had finished the repining. I couldn't chalk it up as a coincidence because when I finished it immediately started popping. Any thoughts?

Thank you!

Has there been any new news on a fix for the P325 error that comes on to what i beleive is a discrepencie against the two coolant sensors showing differently during warmup. < because one is reading actual water temp and one is re routed for i cant remember which is which but its either EBC or ethano...

So on pump 91 I'm running around 15 psi with anywhere from 2%-10% ethanol at around 75ish injector duty cycle. But when I pump E85 in I need to subtract boost so my injectors don't max.

If I have ID1ks and actually have to reduce psi the higher the E content can I put negative (whole #'s in as "-3.1") when I save an re upload it comes back as a rounded super high number like 125.556 etc. (and looks to be a positive number) in that cell.

Just out of curiosity. If it was cleared, would it had erased, flashed to 100%, finalize and then say flash fail? Cause I had tried a million different things including powering everything off. Restarting computer and just plugging the touch in, and it didnt upload or correct itself until I reinstal...