KTuner.com

So I'm trying to set up my boost controller running 3 port electronic boost controller, verified boost controller is working by letting purge control active the boost controller, once verified boost controller is operational, i enable pwm1, and set low/high switch to alwise on, then set my boost tar...

is there a way to adjust afr, trying to tune my boost fuel map on standard closeloop setting for boost calibration map , every time do a pull ktuner wants 12.00 afr in boost, tried to find afr target table like kpro, cant seem to find it in the map in the drop down box, the only choice I see is run ...

so I was at the track today, was trying to use the 2 step feature, tested the system prior to my run work fine, go to stage and pull the e brake, and slipped the clutch to preload my drivetrain, and wot, rpm just rev up pass 2 step, tried the advance feature also, goes into 2step then drops out of 2...

car seat for a week, went to start my car up notice check engine light on, scanned code got code p0122 for tps problem clear code and tps started working fine again, drove 15miles and parked car for few hrs, started up car and notice cel back on, check data again and tps reading shows 28%, tried upl...

So far so good the preloaded maps, wow me I did a dyno pull on base map and compare it to to the one with the one with intake and rbc header map since this car has port rbc intake and short ram intake and exhaust, was very impressed gains with no tune, but got another question, is there way away to ...

Thank you, might be hearing from me alot lol, new to this system I know the ends and outs of aem standalone, haltech, hondata, my thoughts was since I couldt play with the system prior to purchasing this unit and based off pictures and videos this system looks almost identical to hondata but so diff...

I don’t know if you ever used hondata kpro or not but kpro’s fuel percent table has hot key to clear the table after you tune it, does this kturner have this feature too, if yes what’s the hot key

so i got a aem 30-4110 wideband kit, and want to replace factory af sensor with the aem wideband, my question is do i remove the af pin and install aem wide band siginal in pin, or will i have use ptank or eld for input also where do i calibrate my wide band? is the box next wideband selection, I co...