KTuner.com

Take a look at those settings again. I'm sure it will stick out if you understand what min and max mean. I am assuming you are referring to Max A/F Ratio in the wideband logging area? If so, Are we talking Max lean? Max Rich? Max Voltage? Max settings I want to run? How am I supposed to know the wi...

1. I would just like a more detailed manual.
2. Cells to change color after editing until uploaded.
3. graphing for the analog inputs.
4. A full lambda overlay table

You can always see map trace on the fuel maps. Putting fuel maps into lambda mode with preference settings that are being met will overlay values. See your settings and verify they're being met. Yea, the map trace works just fine. I just cannot get values to populate on the overlay or the percentag...

I would switch off of my main tab and switch to a custom graph tab I sentup too look at the data and make changes. Then I realized that they were not matching once I switched back.

Which charts would upload in this case? The most recently changed or the main tab tables?

So I have been working with the software alot trying to figure out how everything works. I found last night that after doing a log I switched over to the charts tab where I have the maps and 2d tables. I realized that they are not linked. Changed made on the charts tab tables do not correct the main...

Is there anything that would stop it from doing the trace? I have setup the overlay and changed it around a few times and I can never get vaules to show up. Tuned closed loop on and off. Etc. I am trying to get my part throttle down and having this table work would be great. Could you elaborate on t...

I have tried a bunch of different settings but I cannot seem to get ktuner to show anything in the overlay tables.

Does anything special need to be checked. Turned off or on? Won't show results if you doing something specific? Anything like that?

KTuner wrote:Send in a support email.

I sent in the support email. I am currently using a beta and thank you for adding that option in for me.

Sounds like you programmed an input instead of setting up a wideband. There's a note at the bottom of the inputs tab outlining that those aren't for wideband overlay. I did that because I was using an OEM wideband and just wanted to log an aftermarket wideband to have a reference in the Datalog. It...

I imagine if it was 1.01 you'd see that extra place. The wideband is outputting the proper signals. I can use the logworks software to see the analog output of the gauge and everything seems fine there. ktuner reacting to the gauge but when im at lambda 0.92 it shows 0.90 and when it goes to 0.93 i...