KTuner.com

There is a gauge for ELD Input as well. Hello again I'd like to re-position my WBO2 input to use the gauge available in the ELD input. I can move my WBO2 signal from Ptank to ELD easily enough, what I can't find its where I disable the ELD, since I will be disconnecting the existing ELD input to do...

OK - thank you for that info. I will look elsewhere.

Hope you had a good Thanksgiving!

Just trying to cover all possible causes for the System WBO2 failures. '05 RSX ECU 37820-PND-A63. JDM '05 K24A3. I have installed: Bosch 15482 (actually repackaged Denso) (Sept. 2018) Denso 234-4454 (July 2021) KAX 234-9066 (Dec 2021), Denso 234-9066 (Jun 2023) Finally a Honda packaged 36531-RBB-003...

Thank you for the clarification.

When I install & run K-tuner (connected to ECU), K-Tuner will switch registration to the new laptop? Just confirming I don't need to do anything with the old laptop first... following directions (existing account) from your "Help/Account Registration" page https://i.postimg.cc/s3Nzc1jm...

Many thanks for responding - took me awhile to find it in the general parameters - I'll make some adjustments & see how it goes.

I can make the software see 80 as 100, that's simple enough, but I prefer accurate information as relayed by the ECU. Think about the WOT settings for TPS that are set to 74%. That's because 80% as a max was clearly planned. Where do I find this? I can't find any of the WOT parameters, or find ment...

OK - so I get it is unused from the factory. I also read where you said it can be enabled, which I did.

You are not answering the simple question as to what the scale is in your software parameter window. Is it Celsius or Fahrenheit, or some other interpolated figure??

You should really read the thread if you plan on replying to it. Here are two responses from this very thread. The Radiator Fan output is not used on the RSX from the factory, but can be enabled in the software on the pin labeled for the output, looking at the 05-06 side of the conversion harness. ...

Thank you - yes, I see it in the list. The values don't jive with the WBO2 controller, so I will have to review the table I used, it came with the controller, but something has to be wrong.