In Closed Loop Settings, there are "WOT MAP Based Engagement" and "WOT TPS Engagement" tables. Does it require both table's inputs to be met before WOT is engaged(RPM/mBar -and- RPM/TPS), or will WOT engage when just one of the table's inputs are met(RPM/mBar -or- RPM/TPS)???
In VTEC Settings, what is the difference between "Lower" and "Upper" engage/disengage? Low Load & High Load? There is also the "VTEC Engagement Window" table, which am I correct to assume that this table is also MAP based? If so, how would that be used if the VTEC Engage/Disengage is set to occur at a specific RPM? Is this a one-or-the-other type situation as well?
Also, in any "MAP Based" table, what would you put in the fields if you do not want MAP Based actions to be made?
WOT and VTEC Engage & Disengage
Re: WOT and VTEC Engage & Disengage
Hello,
Please see the relevant help topics covering these settings for more information:
http://ktuner.com/KTunerHelp/vtec.htm
http://ktuner.com/KTunerHelp/closed_loop_settings.htm
Please see the relevant help topics covering these settings for more information:
http://ktuner.com/KTunerHelp/vtec.htm
http://ktuner.com/KTunerHelp/closed_loop_settings.htm
Re: WOT and VTEC Engage & Disengage
I didn’t notice the online help page had been updated recently. Cool thanks!
Re: WOT and VTEC Engage & Disengage
No problem!