Fan Control Output

Post Reply
daje00
Posts: 52
Joined: Tue Jul 23, 2013 11:36 am

Fan Control Output

Post by daje00 »

Hi,
Just a quick question about the fan output settings. I noticed that my tuner had this set at 190 engage and 170 disengage. I noticed that this made my temp gauge move by a small amount after the fan comes on and then it climbs again a bit after the fan goes off reflecting the 20 degree change but it doesn't do that with the stock calibration. The preloaded calibrations don't have these numbers, I think it has 1832 for both engage and disengage. Which should i be using and why such high numbers for the preloaded calibrations? Do those high numbers allow the car to cool directly from the fan switch temp sensor which i have observed turns the fan on at 203 degrees and off at 196. Thanks.
KTuner
Site Admin
Posts: 3744
Joined: Mon Jul 22, 2013 8:13 pm

Re: Fan Control Output

Post by KTuner »

As the numbers would indicate, it's not used factory.
daje00
Posts: 52
Joined: Tue Jul 23, 2013 11:36 am

Re: Fan Control Output

Post by daje00 »

I'm sorry but your response didn't make sense.
Last edited by daje00 on Sat Aug 15, 2020 6:55 pm, edited 1 time in total.
KTuner
Site Admin
Posts: 3744
Joined: Mon Jul 22, 2013 8:13 pm

Re: Fan Control Output

Post by KTuner »

Let's try a reword. The FAN output is not used from the factory, hence the values.
daje00
Posts: 52
Joined: Tue Jul 23, 2013 11:36 am

Re: Fan Control Output

Post by daje00 »

Ok, so with those numbers it's running directly from the fan temp switch. Thanks.
Post Reply

Return to “05-06 RSX Specific”