Page 4 of 4

Re: 07 accord CM5 tuning options

Posted: Fri Oct 05, 2018 11:22 pm
by bianyy
KTuner wrote:The idle target is the same in either mode, as you can clearly see the tables aren't labeled P D N etc. Please read my post again to see if it now makes sense.
Hi my friend
The problem is they are not the same as you said.
idle is 700 on D and 800 on P when setting 700 in kcl.
if set 800 in kcl, idle is 800 on both D and P with no prob.
Please let me know how can I get idle on both D and P same as 700.

Check the last minute of attched log to see I showed 20 second on D and another 20 on Neutral.
thank you very much.

Re: 07 accord CM5 tuning options

Posted: Sat Oct 06, 2018 5:58 pm
by KTuner
Again, because load has been introduced. I don't think you caught that.

Re: 07 accord CM5 tuning options

Posted: Sat Oct 06, 2018 11:37 pm
by bianyy
KTuner wrote:Again, because load has been introduced. I don't think you caught that.
ok lets only talk on P and N.
How can I set idle of P to 700 RPM. Just let me know this , thanks.

Re: 07 accord CM5 tuning options

Posted: Mon Oct 08, 2018 3:32 pm
by KTuner
You mentioned you already had, and those are the only target tables available.

Re: 07 accord CM5 tuning options

Posted: Mon Oct 08, 2018 10:18 pm
by bianyy
KTuner wrote:You mentioned you already had, and those are the only target tables available.
It did not take effect on P or N as the datalog.

Re: 07 accord CM5 tuning options

Posted: Tue Apr 16, 2019 3:51 am
by bianyy
Hi Kt

Inject size setting in the calibration come from your software for K24A8 is set to 310cc which was knew as 270cc, do I need to modify this if I am running a K24A2 stock? And what should be injector dead time setting for my application?

Re: 07 accord CM5 tuning options

Posted: Tue Apr 16, 2019 4:38 pm
by KTuner
If the sizes are the same there is no change from factory fueling.

Injector battery offsets are the dead times for the injectors you're using.

Re: 07 accord CM5 tuning options

Posted: Tue Apr 23, 2019 11:45 pm
by bianyy
HI Kt

I need your help on assessing my idle issue.
After stop when I swith from D to N or P. idle RPM suddenly drop to less than 600 RPM (I set 800 RPM in calibration) for 2 seconds and then back to 800. At the time I saw below things, and I also confirmed idle learn procedure finished:

>>>MAP drops to about 22KPa - Normal idle 25kpa
>>>Relative throttle position sensor drops to 1.5 degree - Normal idle 2.12 degree
>>>Injector width drop to 1.9ms - Normal idle 2.3ms

This won't happen if I stop with at D position. Please look at attched kcl and datalog for information.
idle.PNG
(44.97 KiB) Not downloaded yet
K24A_STOCK_VTC_RAAHD_FUEL4.zip
(238.34 KiB) Downloaded 505 times

Re: 07 accord CM5 tuning options

Posted: Wed Apr 24, 2019 12:24 pm
by KTuner
You may be going lean or rich, causing RPM to drop. Monitor your air/fuel during this occurrence.