KTuner.com

Hi Ktuner:

I have a 07 CM5 accord with K24A8 in China market, I'm going to tune my engine with ktuner and do some engine upgrade as well.

If I'm going to put k20a head, forged pistions, superchargers, can I go with 06-07 ktuner on OEM ECU to make the most usage of the hardware?

Can I use K24A8 AT ECU and harness plus 06-07 accord ktuner with 07/08 JDM K24A(this should be same with K24A2) engine longblock? As I don't like to disassemble dash to pull out the harness.

If not, do I need to order a TSX04-06 ECU and harness? As I know TSX0708 ECU is quite expensive.

what about to buy a PRB ecu plus related ktuener on my accord then what is the best engine longblock for me?

Cheers!

I don't know enough about your specific market to give you suggestions. I don't know what ECU you have either.

You can't use an 04-06 TSX ECU, as we mention on the site for the 04-06 TSX platform. They're not compatible.

A PRB won't run an Accord dashboard. Sorry I don't have more info for you.

Hi Ktuner

You are so quick!!!

I'm quite sure my engine is K24A8 with AT tranny, the ecm part number is "37820-RAH-H58".

this should be same specific with American market execption emission settings.

I'm going to swap an RBB engine to my chassis with 6MT, what is the best ecm and correct ktuner model for me ? Can I use accord ecu plus ktuner to drive a tsx engine, or I have to buy a RBB ecu, harness and RBB fit ktuner?

Are ktuners only work with those ecm part numbers listed on your website?

You can use the 06-07 Accord DBW ECU or our TSX package to drive the TSX engine with KTuner.

Can I use 0708 tsx manual ecu with ktuner to tune my 07 accord with the purpose to have reverse lock

another question.can i modify my factory ecu by your end user hardware,I m an electronics engineer:))

You can use an 06-07 Accord AT ECU to gain reverse lock output.

Some have sourced their own headers and managed their own installs. Some have not turned out quite so well.

From my understand of your replies, if I order ktuner prepared 0607 accord AT ECU plus end user system, I will 100% have reverse lock to control tsx 6 mt tranny?

BTW,will this setup can still control an AT tranny?

You will have reverse lock with that ECU.

It can also be used for an AT Accord since it's an AT ECU.

can i order from a ebay dealer , the seller name is turbogixxer2183?if yes do i need to leave any comment to them?