Page 1 of 1

new firmware glitches?

Posted: Sun Jan 14, 2018 7:06 pm
by Moopy62
Just installed newest firmware yesterday and went to upload a map. First time got "upload failed" . cycled power and it said "restore mode" (?I believe). It appeared ok. Then tried another map. Unit seemed to go thru the upload OK and got to the instruction to cycle (key) power and the V2 rebooted saying "Uploading 84%" and never moved. Since it appeared that the map uploaded I recycled power and everything looked normal. Makes me nervous.

Re: new firmware glitches?

Posted: Sun Jan 14, 2018 7:18 pm
by KTuner
Yup, some people are seeing this after keying back on if communication isn't sync'ing up. As long as it says Flash Successful before that, you're fine. We are putting an update out tomorrow for it.