Repurpose IMRC Wiring

[myblackhatch]

Hey everyone

05 RSX base. End user board.

Just switched out the intake to an rbc. This deletes the imrc. That gives me 5 wires available to repurpose if possible. I wanted to add a honeywell fuel pressure sensor. Can I use any of this wiring or do I need to run new wires to the ecu?

I only see eld and fuel tank pressure available in the software.

[KTuner]

The programmable inputs you can use, including those on the R1 board itself, are shown in preferences.

[myblackhatch]

The programmable inputs you can use, including those on the R1 board itself, are shown in preferences.

OK, So I will just need to repin the sensor signal wire to the eld, tank pressure, or one of the four on board positions?

[KTuner]

Any available input listed in the software can be used for monitoring sensors, yes!

[myblackhatch]

Any available input listed in the software can be used for monitoring sensors, yes!

Thank you sir. I just moved one ecu pin over and used the existing wiring and I have a fuel pressure sensor up and running. Easy stuff. Thanks again.

[KTuner]

No problem.