Programmable Outputs (Water/Methanol Wiring)
-
- Posts: 11
- Joined: Wed Jun 22, 2016 1:36 am
Programmable Outputs (Water/Methanol Wiring)
I am looking to run a water/methanol setup and wish to run the activation through Ktuner like many have done with Kpro using the E21 input and E22 output (Nitrous tab). I can not find a schematic on what wires are used for the 6 programmable inputs/outputs that are available. Any input would be greatly appreciated.
Re: Programmable Outputs (Water/Methanol Wiring)
Output Tasks under Factory Output Controls. Each output pin is given. You choose the task that triggers the output in each menu.
-
- Posts: 11
- Joined: Wed Jun 22, 2016 1:36 am
Re: Programmable Outputs (Water/Methanol Wiring)
As we have previously discussed I have set up a input (switch) to activate my water/methanol system.
I am looking to purchase a fail safe (Safe Injection) unit for my system. In the event of no flow it triggers a 12V signal. E16 with 12V applied the ground = off. If 12V is not applied can you confirm that the ground = on?
I am looking to purchase a fail safe (Safe Injection) unit for my system. In the event of no flow it triggers a 12V signal. E16 with 12V applied the ground = off. If 12V is not applied can you confirm that the ground = on?
Re: Programmable Outputs (Water/Methanol Wiring)
Each input states what the activation is in the pulldown menu.