Fan Control Output

Fan Control Output

Postby daje00 » Thu May 11, 2017 1:16 pm

Hi,
Just a quick question about the fan output settings. I noticed that my tuner had this set at 190 engage and 170 disengage. I noticed that this made my temp gauge move by a small amount after the fan comes on and then it climbs again a bit after the fan goes off reflecting the 20 degree change but it doesn't do that with the stock calibration. The preloaded calibrations don't have these numbers, I think it has 1832 for both engage and disengage. Which should i be using and why such high numbers for the preloaded calibrations? Do those high numbers allow the car to cool directly from the fan switch temp sensor which i have observed turns the fan on at 203 degrees and off at 196. Thanks.
daje00
 
Posts: 28
Joined: Tue Jul 23, 2013 11:36 am

Re: Fan Control Output

Postby KTuner » Thu May 11, 2017 2:04 pm

As the numbers would indicate, it's not used factory.
KTuner
Site Admin
 
Posts: 934
Joined: Mon Jul 22, 2013 8:13 pm

Re: Fan Control Output

Postby daje00 » Thu May 11, 2017 2:28 pm

I'm sorry but your response doesn't make sense grammatically and didn't answer any of my questions.
daje00
 
Posts: 28
Joined: Tue Jul 23, 2013 11:36 am

Re: Fan Control Output

Postby KTuner » Thu May 11, 2017 5:20 pm

Let's try a reword. The FAN output is not used from the factory, hence the values.
KTuner
Site Admin
 
Posts: 934
Joined: Mon Jul 22, 2013 8:13 pm

Re: Fan Control Output

Postby daje00 » Sun May 21, 2017 1:53 am

Ok, so with those numbers it's running directly from the fan temp switch. Thanks.
daje00
 
Posts: 28
Joined: Tue Jul 23, 2013 11:36 am


Return to 05-06 RSX Specific

Who is online

Users browsing this forum: No registered users and 1 guest

cron