Page 1 of 1

Speed Density

Posted: Wed Feb 22, 2017 10:36 pm
by Steven Hung
This past weekend I convert to speed density. I tapped into position 1 and 2 in the MAF sensor/IAT sensor 5P connector for an IAT sensor. Temperature reading from the IAT sensor on KTuner is relatively consistence to the engine coolant temperature. My car runs fine with the tune from Turbogixxer. However there is a P0101 Mass Air Flow (MAF) Sensor Performance error code. “P0102 – Mass Sensor” from the KTuner disable/monitor screen is checked to disable the MAF sensor. Is there anything I need to do on the MAF sensor/IAT sensor 5P connector that can help to prevent the P0101 error code?

Re: Speed Density

Posted: Thu Feb 23, 2017 2:12 pm
by KTuner
Email us.