Speed Density

Post Reply
Steven Hung
Posts: 8
Joined: Fri Dec 26, 2014 1:41 pm

Speed Density

Post by Steven Hung »

This past weekend I convert to speed density. I tapped into position 1 and 2 in the MAF sensor/IAT sensor 5P connector for an IAT sensor. Temperature reading from the IAT sensor on KTuner is relatively consistence to the engine coolant temperature. My car runs fine with the tune from Turbogixxer. However there is a P0101 Mass Air Flow (MAF) Sensor Performance error code. “P0102 – Mass Sensor” from the KTuner disable/monitor screen is checked to disable the MAF sensor. Is there anything I need to do on the MAF sensor/IAT sensor 5P connector that can help to prevent the P0101 error code?
KTuner
Site Admin
Posts: 3744
Joined: Mon Jul 22, 2013 8:13 pm

Re: Speed Density

Post by KTuner »

Email us.
Post Reply

Return to “09-10 Fit”