Page 1 of 1
Retaining ECO button features and setting DBW to be linear
Posted: Sat May 11, 2019 2:34 pm
by WhiteOrchid
If I wanted to retain the ECO button features other than the altering of the throttle map, would I just make the ECO DBW map look the same as the standard DBW map?
Also, if I wanted the throttle map to be strictly linear, how would I set the map? I'm new to this all so all the numbers and buttons on the chart mapping page are a little confusing.
TIA
Re: Retaining ECO button features and setting DBW to be line
Posted: Sat May 11, 2019 6:28 pm
by KTuner
You can certainly alter ECO DBW with that map if you have access to it.
Re: Retaining ECO button features and setting DBW to be line
Posted: Sat May 11, 2019 10:58 pm
by WhiteOrchid
I do appear to have access to it, however the map charts for ECO Base and Final appear to be on different scales. Not sure how to make them equal exactly.
***EDIT*** I see why they look different. The ECO base chart is TP/KPH while the Final is TP/RPM. Not sure how to get them to appear on the same scale so I could make them equal.
Re: Retaining ECO button features and setting DBW to be line
Posted: Sun May 12, 2019 9:18 pm
by KTuner
Final should not match ECO or vice versa. The Final DBW table uses the output of the standard table as it's incoming TP value.