Key cycle error

Questions about software installation and registration

Key cycle error

Postby cxcamirand » Wed Oct 30, 2019 12:23 am

Hi,

Just installed the Ktuner to my wife 2019 Crv. I can get the 19.5psi base map flashed but once I gotta do the on/off key cycle I always get a error message telling me I did it wrong. My question is: Does it affect the tune upload? Car run fine exept of all error codes showing in the dash, which from will likely erase after driving for a while.
Thanks a lot
cxcamirand
 
Posts: 1
Joined: Wed Oct 30, 2019 12:16 am

Re: Key cycle error

Postby KTuner » Wed Oct 30, 2019 12:05 pm

If the car runs fine then the flash was successful. Keying off and on resets all systems and the unit communication, which checks for success.
KTuner
Site Admin
 
Posts: 2457
Joined: Mon Jul 22, 2013 8:13 pm


Return to KTuner Software Installation

Who is online

Users browsing this forum: No registered users and 1 guest