Page 1 of 1

Baemap Creator is Empty

PostPosted: Thu Nov 12, 2015 7:52 am
by skiddd
Hi,

I recently purchased KTFLASH1215CIVICR18 from HA Motorsports.

My ECU is 37820-R1Y-L41 (Civic 2013).

I have successfully registered + updated the license of Ktuner installation.
Ktuner has detected my ECU and it has "locked" my ECU VIN properly.

The problem now is that my "Basemap Creator" windows does not have any basemaps for me
to initially upload to my ECU.

I can only see:

- Ktuner Flash Based ECUs -
[+] R18 12-15 Civic



However, when I click the [+] to expand the list, nothing changes except for the [+] changing to [-]...


Only the "Cancel" button is highlighted. Both the "Previous" and "Next" are grayed out...


Where can I download the basemap for my ECU?


Currently, the status bar on the bottom of the Ktuner software reads:

[Logging][Not Live] Module: 37820-R1Y-L41 Datalogging:70fps

Best Regards,

Re: Baemap Creator is Empty

PostPosted: Thu Nov 12, 2015 1:01 pm
by KTuner
I'll fix this for you and issue an update this week.

Re: Baemap Creator is Empty

PostPosted: Mon Nov 16, 2015 10:08 am
by skiddd
Hi,

Any ETA on this fix?

B.R.

Re: Baemap Creator is Empty

PostPosted: Mon Nov 16, 2015 12:38 pm
by KTuner
You can either email us directly or wait for the public update.

Re: Baemap Creator is Empty

PostPosted: Thu Jun 13, 2019 1:29 am
by typhoton
Hello,
I am having the same issue. Purchased the v1.2 for my '13 civic Si and was informed there would be a basemap for the RV6 downpipe (which I have) and other basic mods, but there is nothing in the 'new tune' section. Also, the left panel of my window only has the 'layout' section, there is nothing for main parameters or input/output control or any of the other sections that are supposed to be on the left from the start. Has anyone had this issue? Is there something I missed in the download? Help please!

Re: Baemap Creator is Empty

PostPosted: Thu Jun 13, 2019 2:12 pm
by KTuner
Select your ECU and hit next. Choose a tune.

Re: Baemap Creator is Empty

PostPosted: Fri Jun 14, 2019 3:03 am
by typhoton
Ah. Wow, ok :| ha, all that time and it was right there. But yes I see factory, tune 1, and speed density. Is tune 1 geared for the RV6 downpipe, or is it more general, and if so, where can I get the base tune for that downpipe specifically if it's available? Also, is there a way to input parts for KTuner to calculate from (exhaust and intake diameters for instance), or is it intended more for trial-and-error tuning simply with the parts there?
Thank you!

Re: Baemap Creator is Empty

PostPosted: Fri Jun 14, 2019 2:29 pm
by KTuner
The dyno sheet outlined on the application page mentions the parts it was created with. Works fine with the RV6.