Harness Pinouts
Posted: Tue Dec 19, 2017 3:52 pm
Any chance you have pinouts for the 05-06 harness? I haven't been able to find the C101 pinout anywhere, however I have found the 05-06 ECU plug pinouts.
I accidentally bought a hybrid racing harness so I repined the E plug based on the information I have. I am getting power to all of the correct pins but the ECU still wont boot up. This is the second ktuner ECU I have had this issue with now in the last 2 months. The first one tested fine on a bench but in a vehicle would never connect, so I was sent a new one. Having the same issues again. We tested the ECU in our EE lab at work and with power to A2 and ground to A4 the ktuner board gets status lights, but in the vehicle despite having power to those pins it will not show status lights.
I would like to confirm that the pinouts I have are correct, and that there are no wiring issues with the chassis connections before I have to send this one back as well.
I am attempting to run this in a Canadian EG chassis. Not sure if there is anything weird about the Canadian chassis that would cause this.
I accidentally bought a hybrid racing harness so I repined the E plug based on the information I have. I am getting power to all of the correct pins but the ECU still wont boot up. This is the second ktuner ECU I have had this issue with now in the last 2 months. The first one tested fine on a bench but in a vehicle would never connect, so I was sent a new one. Having the same issues again. We tested the ECU in our EE lab at work and with power to A2 and ground to A4 the ktuner board gets status lights, but in the vehicle despite having power to those pins it will not show status lights.
I would like to confirm that the pinouts I have are correct, and that there are no wiring issues with the chassis connections before I have to send this one back as well.
I am attempting to run this in a Canadian EG chassis. Not sure if there is anything weird about the Canadian chassis that would cause this.