Page 2 of 3
Re: K24a8 ek
Posted: Wed Mar 10, 2021 11:59 am
by KTuner
No problem
Re: K24a8 ek
Posted: Sun May 02, 2021 9:57 pm
by Donnycr
So I can't get my car to start got everything on and plugged in but I got a code says internal control module keep memory alive Kam error
Re: K24a8 ek
Posted: Mon May 03, 2021 11:49 am
by KTuner
KAM error doesn't prevent startup and may mean you didn't wire that correctly.
Re: K24a8 ek
Posted: Tue May 04, 2021 3:31 am
by Donnycr
I got everything figured out but car still won't fire up Kam is gone only few other codes left but easy fix and still won't fire. This is my first time using ktuner so I'm a newbie with it
Re: K24a8 ek
Posted: Tue May 04, 2021 2:53 pm
by KTuner
If you're able to datalog and have immobilizer disabled it is likely something in the wiring. You can verify sensor data looks nominal in datalogging to see if any sensors have failed, too.
Re: K24a8 ek
Posted: Fri May 07, 2021 1:30 am
by Donnycr
So question since I got the 05 06 rsx ecu and running a k20z engine harness would that be a problem?
Re: K24a8 ek
Posted: Fri May 07, 2021 3:20 am
by Donnycr
I guess I needed the jumper u guys sell to work with 05 06 ecu
Re: K24a8 ek
Posted: Fri May 07, 2021 1:42 pm
by KTuner
If you have an 05-06 harness and ECU you don't need a jumper.
Re: K24a8 ek
Posted: Fri May 07, 2021 9:47 pm
by Donnycr
I do not I have a ep3 harness and it's the same as 02 rsx
Re: K24a8 ek
Posted: Fri May 07, 2021 11:08 pm
by KTuner
Donnycr wrote: ↑Fri May 07, 2021 1:30 am
So question since I got the 05 06 rsx ecu and running a k20z engine harness would that be a problem?
Going by what you said, a K20Z harness is an 05-06. If you have an 02-04 harness then the details on the page specifically say you need a conversion harness. An EP3 is a K20a3.