K24a2 in MR2
Posted: Mon Mar 23, 2020 3:06 am
Hi,
I am involved K24A2 MR2 swap project using Ktuner. I am having trouble with Table Ignition and Actual Ignition. For instance, table ignition is 15 degrees and Actual Ignition is 0. Ignition correction shows -15. I have looked to see where it could be pulling this timing from with no luck. I have the knock limit table set to 60, in attempt to eliminate the ignition correction from that. I've zeroed any other ignition corrections and I still always end up with a ignition correction retard that is usually the amount of the table ignition, effectively making the actual timing 0.
My second issue pertains to the Cam Angle table. Any adjustment I make will not change the CAM Commanded or the CAM actual. I've tried different basecodes with no success.
Thank You
I am involved K24A2 MR2 swap project using Ktuner. I am having trouble with Table Ignition and Actual Ignition. For instance, table ignition is 15 degrees and Actual Ignition is 0. Ignition correction shows -15. I have looked to see where it could be pulling this timing from with no luck. I have the knock limit table set to 60, in attempt to eliminate the ignition correction from that. I've zeroed any other ignition corrections and I still always end up with a ignition correction retard that is usually the amount of the table ignition, effectively making the actual timing 0.
My second issue pertains to the Cam Angle table. Any adjustment I make will not change the CAM Commanded or the CAM actual. I've tried different basecodes with no success.
Thank You