Page 1 of 1

Ktuner cycles between connected and disconnected

Posted: Sun Aug 05, 2018 4:34 pm
by asrautox
I've got a Ktuner V1.2 and have successfully flashed the stage 2 file to my ECU (Honda Accord 2.0t 10at). When trying to go back and upload file changes to the car, the Ktuner now just cycles between connected and disconnected and will not allow me to upload a new file (upload bar not highlighted). I also am not able to activate any sort of logging parameters while driving. This is very frustrating.

Re: Ktuner cycles between connected and disconnected

Posted: Mon Aug 06, 2018 3:52 pm
by KTuner
If it's still plugged into the vehicle the unit does go to sleep without ECU activity. Plug it in fresh or key on so it wakes up. The LED indicates everything you need to know about the status. Contact support by email if you still can't figure it out.

Re: Ktuner cycles between connected and disconnected

Posted: Tue Aug 07, 2018 12:01 am
by asrautox
It's not going to sleep. It's never connecting. It says connected for a second then switches between connected and disconnected ad infinitum.. Doesn't matter if I've just plugged it in or not.

Re: Ktuner cycles between connected and disconnected

Posted: Tue Aug 07, 2018 12:08 am
by KTuner
No mention of whether it's still plugged into the vehicle at that point or what the LED does. Feel free to reach out to support via email and include those details. Info@KTuner.com

Re: Ktuner cycles between connected and disconnected

Posted: Mon Aug 13, 2018 3:35 pm
by Jraney0815
Did your issue get fixed?

Re: Ktuner cycles between connected and disconnected

Posted: Mon Aug 13, 2018 10:24 pm
by KTuner
It was asleep.