WOT and VTEC Engage & Disengage

Ask your general questions about KTuner
Post Reply
Mada51589
Posts: 25
Joined: Thu Nov 09, 2017 3:13 pm

WOT and VTEC Engage & Disengage

Post by Mada51589 »

In Closed Loop Settings, there are "WOT MAP Based Engagement" and "WOT TPS Engagement" tables. Does it require both table's inputs to be met before WOT is engaged(RPM/mBar -and- RPM/TPS), or will WOT engage when just one of the table's inputs are met(RPM/mBar -or- RPM/TPS)???

In VTEC Settings, what is the difference between "Lower" and "Upper" engage/disengage? Low Load & High Load? There is also the "VTEC Engagement Window" table, which am I correct to assume that this table is also MAP based? If so, how would that be used if the VTEC Engage/Disengage is set to occur at a specific RPM? Is this a one-or-the-other type situation as well?

Also, in any "MAP Based" table, what would you put in the fields if you do not want MAP Based actions to be made?
KTuner
Site Admin
Posts: 3744
Joined: Mon Jul 22, 2013 8:13 pm

Re: WOT and VTEC Engage & Disengage

Post by KTuner »

Hello,

Please see the relevant help topics covering these settings for more information:

http://ktuner.com/KTunerHelp/vtec.htm

http://ktuner.com/KTunerHelp/closed_loop_settings.htm
Mada51589
Posts: 25
Joined: Thu Nov 09, 2017 3:13 pm

Re: WOT and VTEC Engage & Disengage

Post by Mada51589 »

I didn’t notice the online help page had been updated recently. Cool thanks!
KTuner
Site Admin
Posts: 3744
Joined: Mon Jul 22, 2013 8:13 pm

Re: WOT and VTEC Engage & Disengage

Post by KTuner »

No problem!
Post Reply

Return to “General Questions”