Page 1 of 1

WOT and VTEC Engage & Disengage

Posted: Wed Jan 10, 2018 4:43 pm
by Mada51589
In Closed Loop Settings, there are "WOT MAP Based Engagement" and "WOT TPS Engagement" tables. Does it require both table's inputs to be met before WOT is engaged(RPM/mBar -and- RPM/TPS), or will WOT engage when just one of the table's inputs are met(RPM/mBar -or- RPM/TPS)???

In VTEC Settings, what is the difference between "Lower" and "Upper" engage/disengage? Low Load & High Load? There is also the "VTEC Engagement Window" table, which am I correct to assume that this table is also MAP based? If so, how would that be used if the VTEC Engage/Disengage is set to occur at a specific RPM? Is this a one-or-the-other type situation as well?

Also, in any "MAP Based" table, what would you put in the fields if you do not want MAP Based actions to be made?

Re: WOT and VTEC Engage & Disengage

Posted: Wed Jan 10, 2018 8:30 pm
by KTuner
Hello,

Please see the relevant help topics covering these settings for more information:

http://ktuner.com/KTunerHelp/vtec.htm

http://ktuner.com/KTunerHelp/closed_loop_settings.htm

Re: WOT and VTEC Engage & Disengage

Posted: Thu Jan 11, 2018 1:35 pm
by Mada51589
I didn’t notice the online help page had been updated recently. Cool thanks!

Re: WOT and VTEC Engage & Disengage

Posted: Thu Jan 11, 2018 2:05 pm
by KTuner
No problem!