K swap using element ecu and harness
K swap using element ecu and harness
hello all. Im new here and have a question. Motor is 05 k24a2 into a 00 civic. I have a ktuner element ecu and element harness. Do i have to swap all my sensors out to element sensors? And also if anyone knows how to repin for tps sensor. Tia!
Re: K swap using element ecu and harness
You would have to swap it from Drive By Wire to Drive By Cable in order to run the engine properly with a supported Element ECU.
Re: K swap using element ecu and harness
That i know. I already have a skunk2 cable tb. But just wondering if all the sensors will work without having to swap them.
Re: K swap using element ecu and harness
What I mentioned is all. If you're using an Element harness you're already pinned for standard TPS.
Re: K swap using element ecu and harness
Reason i ask also is because when doing a k24a2 swap in an element everyone changes out their sensors to element sensors. Not sure what the reason is if youre saying i wouldnt need to. But i hope i dont have to.
Re: K swap using element ecu and harness
Sounds like a lot of wasted time to me.
Re: K swap using element ecu and harness
Would you happen to know anyone that tunes ktuner in the midsouth? Im in memphis, tn
Re: K swap using element ecu and harness
The only people who I can say for sure are those listed on the dealer page. If you want to try remote tuning, contact Derek at Innovative Motorworks.