KTuner.com

I've noticed on all my logs that the TPS reading never gets higher than 82.5%. Should I be seeing 100 at WOT? We adjusted it to get the idle back where it should be but that was before KTuner was installed. Idle is still fine . Anyone?

~80 is normal. I'll likely have an option so you can set the spread and have it read 100 there.

Even on my stock RSX when i used my scan tool it never read 100% at wot, the most was 92.5%.

I test a fully stock RSX K20z1

the TPS closed is a 9%
TPS fully open is 93%

Garrett wrote:I test a fully stock RSX K20z1

the TPS closed is a 9%
TPS fully open is 93%

So key on , car not started .. 9% or are you talking at idle, car warmed up...
I had to drill out the stock "rivets" in order to adjust it. I just stopped when the idle was corrected. Before I did that it seemed to hunt for steady idle . Thanks for the replies...

KTuner wrote:~80 is normal. I'll likely have an option so you can set the spread and have it read 100 there.

Cool! Thanks...

Lol, gonna shorten up this SIG, scrolling forever on my iphone to read a damn post or reply....

Garrett wrote:I test a fully stock RSX K20z1

the TPS closed is a 9%
TPS fully open is 93%

That will cause idle issues. It should be 0 or very close to 0 at close in the KTuner software.

KTuner wrote:

Garrett wrote:I test a fully stock RSX K20z1

the TPS closed is a 9%
TPS fully open is 93%

That will cause idle issues. It should be 0 or very close to 0 at close in the KTuner software.

so I need to move the TPS itseft since we don't have ajustement value in the software

Factory shouldn't need adjustment like that. I wonder what happened.