Shift light.
Shift light.
Is there a CEL shift light feature in the software, i wasn't able to find it?
Re: Shift light.
You can set one up using an output, but you'll override normal CEL operation.
Re: Shift light.
KTuner- Please take the screenshot "output CEL shift light" settings in KTuner
I have a problem with these settings
I have a problem with these settings
Re: Shift light.
You can setup an output to activate whenever you want, based on RPM for a shiftlight I'd imagine, then choose the Output as the task for the MIL output in the Factory Outputs settings.
Re: Shift light.
I set:
- Arming Act to Check Engine Light Control
- Revs PerMinute xxx eg. 1500
- and really it's doesn't works
I try Invert for Arming Activation and output settings and ... no
MIL works ok on start up the engine. EDM K20A2.
- Arming Act to Check Engine Light Control
- Revs PerMinute xxx eg. 1500
- and really it's doesn't works
I try Invert for Arming Activation and output settings and ... no
MIL works ok on start up the engine. EDM K20A2.
Re: Shift light.
I'm not sure what you did there.
Setup Output X to activate on your parameters, whatever RPM you want it to activate at.
Then set Malfunction Indicator Light Output to Active Based On: Output X Active. X being the output number you chose.
Setup Output X to activate on your parameters, whatever RPM you want it to activate at.
Then set Malfunction Indicator Light Output to Active Based On: Output X Active. X being the output number you chose.
Re: Shift light.
Ktuner, your program has a problem with shiftlight....
me too does not work... in K20A2 EDM
I tried to change everything...
Please Insert a screenshot of a good set of shiftlight settings
me too does not work... in K20A2 EDM
I tried to change everything...
Please Insert a screenshot of a good set of shiftlight settings
Re: Shift light.
I described here how to do it. You can watch both the Output and the MIL in datalogging to verify they're being activated.KTuner wrote:I'm not sure what you did there.
Setup Output X to activate on your parameters, whatever RPM you want it to activate at.
Then set Malfunction Indicator Light Output to Active Based On: Output X Active. X being the output number you chose.