KTuner.com

Is there a CEL shift light feature in the software, i wasn't able to find it?

You can set one up using an output, but you'll override normal CEL operation.

KTuner- Please take the screenshot "output CEL shift light" settings in KTuner
I have a problem with these settings

You can setup an output to activate whenever you want, based on RPM for a shiftlight I'd imagine, then choose the Output as the task for the MIL output in the Factory Outputs settings.

I set:
- Arming Act to Check Engine Light Control
- Revs PerMinute xxx eg. 1500
- and really it's doesn't works

I try Invert for Arming Activation and output settings and ... no

MIL works ok on start up the engine. EDM K20A2.

I'm not sure what you did there.

Setup Output X to activate on your parameters, whatever RPM you want it to activate at.

Then set Malfunction Indicator Light Output to Active Based On: Output X Active. X being the output number you chose.

Ktuner, your program has a problem with shiftlight....
me too does not work... in K20A2 EDM
I tried to change everything...

Please Insert a screenshot of a good set of shiftlight settings

KTuner wrote:I'm not sure what you did there.

Setup Output X to activate on your parameters, whatever RPM you want it to activate at.

Then set Malfunction Indicator Light Output to Active Based On: Output X Active. X being the output number you chose.

I described here how to do it. You can watch both the Output and the MIL in datalogging to verify they're being activated.