Shift light.

Post Reply
2.2Lude
Posts: 15
Joined: Thu Sep 25, 2014 1:59 am

Shift light.

Post by 2.2Lude »

Is there a CEL shift light feature in the software, i wasn't able to find it?
KTuner
Site Admin
Posts: 3745
Joined: Mon Jul 22, 2013 8:13 pm

Re: Shift light.

Post by KTuner »

You can set one up using an output, but you'll override normal CEL operation.
MrCk
Posts: 9
Joined: Tue Mar 08, 2016 5:16 pm

Re: Shift light.

Post by MrCk »

KTuner- Please take the screenshot "output CEL shift light" settings in KTuner
I have a problem with these settings
KTuner
Site Admin
Posts: 3745
Joined: Mon Jul 22, 2013 8:13 pm

Re: Shift light.

Post by KTuner »

You can setup an output to activate whenever you want, based on RPM for a shiftlight I'd imagine, then choose the Output as the task for the MIL output in the Factory Outputs settings.
mdfk
Posts: 9
Joined: Fri Oct 17, 2014 4:12 pm

Re: Shift light.

Post by mdfk »

I set:
- Arming Act to Check Engine Light Control
- Revs PerMinute xxx eg. 1500
- and really it's doesn't works

I try Invert for Arming Activation and output settings and ... no :|

MIL works ok on start up the engine. EDM K20A2.
KTuner
Site Admin
Posts: 3745
Joined: Mon Jul 22, 2013 8:13 pm

Re: Shift light.

Post by KTuner »

I'm not sure what you did there.

Setup Output X to activate on your parameters, whatever RPM you want it to activate at.

Then set Malfunction Indicator Light Output to Active Based On: Output X Active. X being the output number you chose.
MrCk
Posts: 9
Joined: Tue Mar 08, 2016 5:16 pm

Re: Shift light.

Post by MrCk »

Ktuner, your program has a problem with shiftlight....
me too does not work... in K20A2 EDM
I tried to change everything...

Please Insert a screenshot of a good set of shiftlight settings
KTuner
Site Admin
Posts: 3745
Joined: Mon Jul 22, 2013 8:13 pm

Re: Shift light.

Post by KTuner »

KTuner wrote:I'm not sure what you did there.

Setup Output X to activate on your parameters, whatever RPM you want it to activate at.

Then set Malfunction Indicator Light Output to Active Based On: Output X Active. X being the output number you chose.
I described here how to do it. You can watch both the Output and the MIL in datalogging to verify they're being activated.
Post Reply

Return to “KTuner Software”